Encore ENHWI-SG Manuel d'utilisateur télécharger pdf (Page 40)

3.5.5 Firewall Rule

This screen enables you to set up the firewall. The router provides basic firewall

functions, by filtering all the packets that enter the router using a set of rules. The rules

are in an order sequence list--the lower the rule number, the higher the priority the rule

has.

Enable: Click to enable or disable the firewall rule profile.

Name: Type a descriptive name for the firewall rule profile.

Action: Select whether to allow or deny packets that conform to the rule.

Inactive Timeout: Type the number of seconds of network inactivity that elapses before

the router refuses the incoming packet.

Source: Defines the source of the incoming packet that the rule is applied to.

● Interface: Select which interface (WAN or LAN) the rule is applied to.

● IP Range Start: Type the start IP address that the rule is applied to.

● IP Range End: Type the end IP address that the rule is applied to.

Destination: Defines the destination of the incoming packet that the rule is applied to.

● Interface: Select which interface (WAN or LAN) the rule is applied to.

● IP Range Start: Type the start IP address that the rule is applied to.

● IP Range End: Type the end IP address that the rule is applied to.

● Protocol: Select the protocol (TCP, UDP, or ICMP) of the destination.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 49 50

Pas de commentaire

Encore ENHWI-SG Manuel d'utilisateur Page 40