Encore IEEE 802.11GWIRELESS BROADBAND ROUTER Spécifications télécharger pdf (Page 28)

Configuring Your Wireless Network 24

– Then, enter this PIN in the Enter Client’s PIN field provided on the router and click

Next. You have 4 minutes to enable WPS on the router using this method.

Using either method, the client wireless device will attempt to detect the WPS signal from the

router and establish a wireless connection in the time allotted.

• If no connection is detected:

– WPS did not establish a secure connection with a wireless device.

– Neither the SSID nor the WPA/WPA2 security settings were configured on the router.

• If a connection is established:

– The router WPS screen displays a message confirming that the wireless client was

successfully added to your wireless network.

– The router generated an SSID, implemented WPA/WPA2 wireless security (including

a PSK security password), and broadcast these settings to the client; the client now

shares the same security settings as the router.

4. Note your SSID and WPA/WPA2 PSK security password (whether previously set or

generated) for your wireless network.

Figure 16

If the router was already configured manually, and either WPS/PSK or

WPA2/PSK security enabled and a PSK security password selected, then

the client now shares these same security settings.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Pas de commentaire

Encore IEEE 802.11GWIRELESS BROADBAND ROUTER Spécifications Page 28